Quick answer
If you ship or receive dangerous goods by rail, check section 14 of every SDS you receive: the UN number, the proper shipping name, the transport class and the packing group must match an entry in RID Table A. RID itself does not require an SDS, but REACH Annex II requires section 14 to give the RID classification, and your transport documents rely on it. The current edition is RID 2025, applicable from 1 January 2025.
What it is
RID is the international rulebook for carrying dangerous goods by rail. It is Appendix C to the Convention concerning International Carriage by Rail (COTIF) and is managed by OTIF in Berne. It classifies goods for transport, lists them in the Dangerous Goods List (Table A), and sets rules for packaging, tanks, labels, placards, documents, loading and training. It has the same structure as ADR for road, so SDS often show one “ADR/RID” block in section 14. A new edition applies every two years.
Does it apply to you?
- You send dangerous goods by rail, alone or in a transport chain: you are a consignor with duties under RID.
- You pack, load or fill wagons, tank wagons or containers: you have your own duties as packer, loader or filler.
- You receive dangerous goods by rail: as consignee you must not delay acceptance without good reason and must check after unloading that the RID rules that concern you are met.
- You are in the EU: RID also applies to national rail transport through Directive 2008/68/EC.
- You are in one of the 45 RID Contracting States, for example Belgium, the Netherlands or Switzerland.
Managing your safety data sheets
RID sets no SDS rules of its own. In the EU, REACH Article 31 and Annex II require section 14 of the SDS to give the transport classification under RID, ADR and ADN where relevant.
| Task | What applies |
|---|---|
| Get an SDS for every hazardous product | Set by REACH. Ask your supplier for the SDS before the first rail shipment. |
| Check section 14 | UN number (14.1), proper shipping name from RID Table A (14.2), class and subsidiary risks (14.3), packing group (14.4), environmental hazard (14.5), special precautions (14.6). |
| Check the version | Section 14 should reflect the current RID edition. Replace SDS when your supplier issues a new version. |
| Use the data for shipping | The consignor gives the carrier the information and transport documents in a traceable form, based on the classification. |
| Keep a chemical register | Not required by RID. Linking each product to its UN number, class and packing group makes shipping and the safety adviser’s annual report easier. |
| Give workers access | Workers who handle dangerous goods must be trained for their tasks; the SDS supports that training. |
| What the inspector asks | Correct transport documents, markings and labels, training records, the safety adviser’s appointment and annual report, and a security plan for high consequence goods. |
What you need to do
- Collect a current SDS for every product you ship or receive by rail.
- Check that section 14 gives a UN number, shipping name, class and packing group.
- Compare these data with the matching entry in RID Table A.
- Ask the supplier to correct an SDS when section 14 does not match Table A.
- Use the section 14 data for the transport document and the labels.
- Inform the carrier in advance of the total gross mass of goods packed in limited quantities.
- Appoint a safety adviser if your activities include consigning, packing, loading, filling or unloading dangerous goods by rail, unless an exemption applies.
- Train every employee involved, keep the training records and include security awareness.
- Keep copies of transport documents for at least three months.
What NextSDS checks for you
| Check | SDS data used | What it tells you |
|---|---|---|
| UN number exists in RID | Section 14.1 | Whether the UN number is valid in RID 2025 |
| Shipping name, class and packing group | Sections 14.2 to 14.4 | Whether the combination matches a Table A entry |
| Carriage prohibited | Section 14.1 | Whether the entry is marked “carriage prohibited” in Table A |
| Limited and excepted quantities | Section 14.1 with Table A | The limited quantity and excepted quantity code for the entry |
| High consequence goods | Sections 14.3 and 14.4 | Whether a security plan may be needed |
| Consistency with hazard classification | Sections 2 and 14 | Products classified as hazardous in section 2 but “not regulated” in section 14 |
| SDS date and version | Section 16 and header | Whether the SDS may predate the current RID edition |
Key lists and limits
- RID Table A, Dangerous Goods List. One row per UN entry with class, classification code, packing group, labels, special provisions, limited and excepted quantities, tank codes and hazard identification number. Published in the RID 2025 PDF on otif.org.
- High consequence dangerous goods (Table 1.10.3.1.2). Above the listed quantities a security plan is required, for example 3 000 litres in tanks for flammable liquids of packing groups I and II.
- Limited quantities (Chapter 3.4). Packages of at most 30 kg gross (20 kg for shrink or stretch wrapped trays); wagon marking can be omitted up to 8 tonnes gross of limited quantity packages per wagon or large container.
- Excepted quantities (Chapter 3.5). Codes E0 to E5 set the maximum quantity per inner and outer packaging.
Key dates
- 1 January 2027: planned entry into force of RID 2027, unless enough Member States objected by 17 November 2026. The run out period for RID 2025 then ends on 30 June 2027.
- 25 September 2026: the European Commission adopted a draft delegated directive to refer to RID 2027 in EU law, with transposition by 30 June 2027.
- 17 July 2026: OTIF notified the RID 2027 amendments adopted on 28 May 2026.
- 30 June 2025: end of the run out period for RID 2023 and transposition deadline of Delegated Directive (EU) 2025/149.
- 1 January 2025: RID 2025 applies.
Frequently asked questions
Does RID require a safety data sheet?
No. The SDS duty comes from REACH in the EU. REACH Annex II requires section 14 of the SDS to give the transport classification under RID, ADR and ADN where relevant.
What should section 14 of an SDS show for rail transport?
The UN number, the proper shipping name from RID Table A, the transport hazard class and subsidiary risks, the packing group, whether the product is environmentally hazardous and special precautions for the user.
Is RID the same as ADR?
They share the same structure and the same UN entries in Table A, so the UN number, name, class and packing group are normally identical. RID has its own rail columns, for example tank codes for RID tanks and express parcel codes.
What is the current RID edition?
RID 2025, applicable from 1 January 2025. RID 2027 is planned to apply from 1 January 2027, with a run out period until 30 June 2027.
Do I need a dangerous goods safety adviser for rail?
Yes, if your activities include consigning or carrying dangerous goods by rail, or the related packing, loading, filling or unloading. National authorities may exempt some undertakings, for example those that handle only small quantities.
How long must I keep rail transport documents?
The consignor and the carrier keep a copy of the dangerous goods transport document and the additional information for at least three months.
In which language must the rail transport document be?
In one or more languages, one of which is English, French or German, unless agreements between the countries concerned provide otherwise.
Related frameworks
- ADR: road transport of dangerous goods, with the same UN numbers and classes in section 14.
- IMDG Code: sea transport, which adds marine pollutant and segregation data to section 14.
- IATA DGR and ICAO Technical Instructions: air transport, with quantity limits per package and aircraft type.
- UN Model Regulations: the UN base that every transport mode follows.
- ADN: the same system for inland waterways, with its own table for tank vessels.
- UN GHS: the 16 section SDS whose section 14 carries the transport data.
- SQAS and ESAD: chemical industry assessments of rail operators and logistics providers.
- European Union: REACH, CLP and Directive 2008/68/EC, which makes RID apply to national transport.
- Belgium: an RID Contracting State and EU Member State.
- Netherlands: an RID Contracting State and EU Member State.
- Switzerland: an RID Contracting State outside the EU.
Official sources
- OTIF: RID page
- RID 2025, English (OTIF)
- OTIF depositary notification NOT-26019 on RID 2027
- Directive 2008/68/EC on the inland transport of dangerous goods
- Commission Delegated Directive (EU) 2025/149
- REACH Annex II section 14 (ReachLex)
- REACH Article 31 (ReachLex)
Based on research of 17 November 2026. This page is not legal advice; always check the official text.